Advertisement
4. Remove four large screws from the rear side of the display.
5. nsert the bolts and insulations into the four screwholes as shown in the following figure:
ΠBolt
´ Insulation holder
6. Put the insulation rubber point protruding from the rear top of the display in the groove on the top
of the wall attachment panel. Lift up the display a little bit so that the insulation rubber point at the
bottom of the rear side of the display is put in the groove at the bottom of the wall attachment panel.
(Do not lift the display with any pressure. The insulation rubber at the top may be taken off. )
Samsung Electronics
Œ
´
Handling Description
9-7
Advertisement
