Advertisement
Handling Description
9-2-3 Installing the Display on the Wall Attachment Panel :
1. See the drawing of the wall attachment panel shown in page 14 to check for the stability of the wall
where the PDP is to be installed. If the wall is not strong enough to support the PDP, strengthen the
wall before installation.
2. Fix the wall attachment panel on the wall
using bolts as shown in the following figure:
Fixing bolts must protrude from the wall
appox. 0.6 inches
3. Using the wall attachment panel, you may adjust the angle of the display from 0 to 20 degrees. The
angle can be set in 5 stages with 5 degrees of distance each, using the angle control holes on the sides
of the pane.
When the angle
has been set to 5
degrees.
Angle control holes
9-6
When the angle
has been set to 15
degrees.
5 degrees of tilt
10 degrees of tilt
15 degrees of tilt
20 degrees of tilt
Continued...
When the panel
hasn't been tilted.
No tilt
Samsung Electronics
Advertisement
