Adjusting The Fastening Torque; Installing Hook - Makita DLX2336T01 Instruction Manual

Adjusting the fastening torque

3
4
Fig.7
► 1 . Action mode changing ring 2. Adjusting ring
3. Graduation 4. Arrow
The fastening torque can be adjusted in 16 levels by
turning the adjusting ring. Align the graduations with the
arrow on the tool body. You can get the minimum fas-
tening torque at 1 and maximum torque at 16.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to deter-
mine which torque level is required for a particular
application.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
drill bit
Optional accessory
Fig.8
► 1 . Sleeve
Turn the sleeve counterclockwise to open the chuck
jaws. Place the driver bit/drill bit in the chuck as far
as it will go. Turn the sleeve clockwise to tighten the
chuck. To remove the driver bit/drill bit, turn the sleeve
counterclockwise.
2
1
6
8 10

Installing hook

Optional accessory
WARNING:
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
as too much force or irregular overburden may cause
damages to the tool resulting in personal injury.
CAUTION:
secure it with the screw firmly. If not, the hook may
come off from the tool and result in the personal injury.
CAUTION:
before releasing your hold. Insufficient or unbalanced
hooking may cause falling off and you may be injured.
Fig.9
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool. This can
be installed on either side of the tool. To install the hook, insert it
into a groove in the tool housing on either side and then secure it
with a screw. To remove, loosen the screw and then take it out.
Using hole
WARNING:
unintended purpose, for instance, tethering the
tool at high location. Bearing stress in a heavily
1
loaded hole may cause damages to the hole, result-
ing in injuries to you or people around or below you.
Fig.10
► 1 . Hanging hole
Use the hanging hole at the bottom rear of the tool to hang
the tool on a wall using a hanging cord or similar strings.
9 ENGLISH
Use the hanging/mounting parts
Be careful not to overload the hook
When installing the hook, always
Make sure to hang the tool securely
3
1
2
Never use the hanging hole for
1