Table of Contents
Advertisement
addition, the permissible immission level may differ from country to country. This information is nevertheless
suitable for providing the machine user with an improved assessment of the hazard and risk.
2.5 Vibration specifications
The typically assessed acceleration is < 2.5
2.6 Scope of supply
Wire saw for insulation material DSS 300 cc complete with:
2 saw wires
1 supplementary support plate with glider
1 double-toothed belt
2 cable ties
1 service tool in bracket on the machine
1 operating manual
1 folder "Safety instructions"
1 transport case
2.7 Safety devices
Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- Protective equipment above the base plate
- Lower deflection with saw guard and brake
- Special design of the saw wire
- Riving knife/splitter
- Large base plate and supplementary support plate
- Handles
- Index mechanism with lock and brake
- Hose connector
2.8 Use according to intended purpose
The wire saw for insulation material is exclusively
suitable for cross and lengthwise cutting of insulation
material up to a max. thickness of 300 mm and a
density of max. 180 kg/m
special saw wire provided by MAFELL may be used
(insulation material containing minerals, flax, hemp
and materials with glued on sheathing are expressly
excluded from the intended use). The machine base
plate 3 (Fig. 1) must rest on the workpiece during
2
.
, for which purpose only the
³
cutting. The machine may be operated by one person
only. At the same time, the machine must be held and
guided by its two handles 1 and 2 provided for that
purpose.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
So as to use the machine as intended, comply with
the operating, maintenance and repair instructions
specified by Mafell.
2.9 Residual risks
Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
- Contact with the running saw wire below the base
plate.
- Contact with the cutting members of the standing
saw wire below the base plate.
- Machine backlash if the blade gets stuck in the
workpiece.
- Rupture of the saw wire.
-21-
Advertisement
Table of Contents
