Table of Contents
Advertisement
Roof assembly
54. Position the roof assembly on the machine. Use the
lifting eyes near the front hinges of the side shieldings,
and use the spout support as shown.
NOTE: Make sure that the rubber coupler sits ready is slid
back on the air intake tube (23) before installing the roof
assembly. See Figure 47.
NOTE: Make sure that the chains are set in such a way
that the roof assembly, when lifted, is properly balanced.
NOTE: When lowering check alignment of the air intake
tube (23) and rubber elbow coupler (28) see Figure 46.
55. On the right-hand side of the machine, install the hard-
ware (30) and the hardware (31).
56. On the left-hand side of the machine, install the hard-
ware (31).
57. On the left-hand side of the machine, install the hard-
ware (29).
Engine - Engine and crankcase
47956032 16/02/2016
10.1 [10.001] / 30
37
ZEIL15FR00116AA
38
ZEIL15FR00118AA
39
ZEIL15FR00198AA
40
ZEIL15FR00117AA
Advertisement
Table of Contents
