Using The Wall-Mounted Control Console; Using Wall-Mounted Control Console - Craftsman 139.53918d Owner's Manual

Using the Wall.Mounted
Control Console
THE MOTION DETECTING CONTROL CONSOLE
Press the push button to open or close the door. Press
again to reverse the door during the closing cycle or to
stop the door while it's opening.
This control console contains a motion detector that will
automatically turn on the light when it detects a person
entering the garage. This feature can be easily turned off
for extended work light use.
Light Feature
Press the Light button to turn the opener light on or off. It
will not control the opener lights when the door is in
motion. If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes. Press again to turn
it off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again
for a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor.
Motion Detecting Light Feature: The opener light will
turn on automatically when a person walks in front of the
wall-mounted control console. This feature works by
detecting motion and body heat and may not work in
temperatures around IO0°F, 37.7C. The opener light will
come on for 5 minutes, then shut off automatically if no
additional motion or heat differential is calculated.
To disable this feature, press the Automatic Light On/Off
button on the left side of the control console.
We recommend that you disable the motion sensor when
using the opener lights as working lights. Otherwise, they
will turn off automatically if you are working beyond the
sensor's range.
Lock Feature
Designed to prevent operation of the door from hand-held
remote controls. However, the door will open and close
from the control console, the Outside Keylock and the
Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push bar light will flash as long as the Lock
feature is on.
To turn off, press and hold the Lock button again for
2 seconds.The push bar light will stop flashing. The Lock
feature will also turn off whenever the "learn" button
is activated.
Motion Detecting
Light On/Off
Learn
Hour
Minute
Bar
Language
Degrees (F/C)
ight Button
Lock Button
Learn Feature
The control console is equipped with a LEARN button to
assist in learning remote controls to the unit. Press the
LEARN button once to initiate LEARN mode and the
display will show 'Learn Remote Control - Press Learn
Button Again to Confirm.' Press the LEARN button a
second time and the display will show 'Learn Mode -
Press Remote Control Button to Learn Remote.' Press
the button of the remote control to be learned and the
worklight will blink to confirm the remote control has
been learned.
Hour and Minute Feature
Press or hold either of these side buttons to increment
the hour or minute displayed on the LCD display.
Language Feature
Press this side button to toggle between the three
languages - English, Spanish, and French.
Degrees F/C Feature
Press this side button to toggle the temperature units
between Fahrenheit and Celsius.
Additional feature when used with the 3-Function
hand-held remote
To control the opener lights:
1. With the door closed, press and
hold a small remote button that you
want to control the light.
2. Press and hold the Light button on
the control console.
3. While holding the Light button, press and hold the Lock
button on the control console.
4. After the opener lights flash, release all buttons.
31