Pro-Form TRAINER 8.7 User Manual page 14

IMPORTANT: You will connect wires in one or
more of the following steps. For your tread-
mill to function properly, connect the wires as
described below. Note: The actual wires may
look different from the wires shown.
V
First, firmly push the wires (V) into each connec-
Y
tor (W, X) to make sure that the wires are fully
seated.
W
Next, turn the wires so that the latch (Y) on one
connector (W) is on the same side as the catch
Z
(Z) on the other connector (X). (Note: If there
are red dots on the connectors, turn the wires so
X
that the red dots are on the same side.) Then,
V
slide the connectors together; the connectors
should slide together easily and snap into
place with an audible click.
Then, pull on the connectors (W, X) to make
sure that they are connected; do not pull on the
wires (V). To see a video about connecting
wires, scan the QR code or go to my.iFIT.com.
12. Connect the Upright Wire (74) to the indicated
12
wire (H). Make sure to connect the wires as
described above.
84
Then, connect the console wires (F) to the wires
(I) from the console base (84) and to the Ground
F
Wire (100). Make sure to connect the wires as 100
described above.
I
H
74
14