STORAGE & CARE
PROPER STORAGE
Preparing your steamer for storage is quick and simple. When you have completed your tasks,
follow the steps listed below.
1. Push the Power ON/OFF Button (Steam Status Light will turn off) and unplug power cord.
2. Allow unit time to cool (at least 30 minutes).
3. Remove Water Tank and drain any remaining water into a sink or tub to minimize potential
mineral build-up. Replace Water Tank when done.
4. Wrap cord with supplied "hook and loop" strap when storing. Do not wrap cord around the
product.
5. Store steamer in a cool, dry location.
MINERAL BUILD-UP
A common maintenance need for steam appliances is the removal of build-up caused by high
mineral content in many municipal water supplies. This mineral build-up may cause the unit to
spit water, limit the effectiveness and reduce the life of your steamer.
The best way to minimize mineral build-up is to use distilled or de-mineralized water when
using your steamer. In addition, it is recommended that the cleaning procedure below be
followed at least once a month in order to remove any deposits that form. This will help to
extend the life of your steamer and keep it functioning at its maximum potential.
TO REMOVE MINERAL BUILD-UP:
1. Follow STEPS 1-3 under Proper Storage section above. However, do not replace Water Tank
at the end of STEP 3.
2. Fill Measuring Cup (not included) with 1 oz. (29.6 ml) distilled water and 1 oz.
(29.6 ml) vinegar.
3. Slowly pour water-vinegar solution into Water Tank through Fill Hole, then replace Water
Tank Cap.
4. Plug in power cord and press ON/OFF Button to turn unit on. Once heated, press the Steam
Button to allow unit to produce steam for 1 minute, then turn unit off.
5. Allow unit to sit for approximately 30 minutes, then press ON/OFF Button to turn unit on
again and repeat Step 4 above. Repeat until the remainder of the Water Tank's contents are
steamed out.
6. Once Water Tank is drained, turn unit off and refill Tank with 5 oz. (148 ml) of fresh distilled
water. Allow unit to steam until Water Tank is empty. Repeat as necessary until vinegar odor
dissipates.
7. Turn unit OFF, unplug power cord and store steamer in a cool, dry location.
IMPORTANT: On average, it is recommended that you follow the mineral build-up removal
procedure once per month (if unit is used once every week). More frequent use may
require following the procedure more often in order to keep your steamer operating at full
potential. Do not exceed 1 hour of use without cleaning out mineral build-up.
8
| ENGLISH
Need help?
Do you have a question about the NOMAD and is the answer not in the manual?