Multiple Ssid - TRENDnet TEW-929DRU User Manual

TRENDnet User's Guide
wireless client devices. This feature is also known as L2
isolation or L2 client isolation.
▪
WMM Mode – This feature enables Wi-Fi Multimedia QoS
prioritization for wireless client devices that support WMM
using the default priority level settings. Unchecking this
option will disable WMM QoS on the wireless band.
▪
Enable HT20/40 coexistence – Applies to 2.4GHz band only.
This option is enabled by default to ensure connection
stability on the 2.4GHz band. When this option is enabled, the
radio will attempt to operate at the higher 40MHz channel
width mode if there are not too many neighboring wireless
networks. If the current wireless environment is too busy the
radio will automatically operate at the lower 20MHz channel
width mode. Unchecking this option forces the radio to
operate at the higher 40MHz channel which cause instability
if there are too many neighboring 2.4GHz wireless networks.
© Copyright 2023 TRENDnet. All Rights Reserved.
Multiple SSID - This tab involves the configuration parameters for the additional SSIDs
for a specific wireless band. Up to 7 additional SSIDs can be created per wireless band.
You can view a summarized list of the current operating SSID and channels under Status
> Overview in the Wireless section.
•
General Setup
o
Enabled – Checking this option will enable the additional SSID on the
specific wireless band. Before checking Enabled, click the Multiple SSID
drop-down and select which index number SSID to configure.
o
Multiple SSID – Click the drop-down to select the index number SSID
to configure, then check Enabled.
o
ESSID – This is wireless network name setting for the additional SSID
band. This name will differentiate your wireless network from other
neighboring wireless networks so you can identify and connect your
wireless client devices. Enter the wireless network name to assign to
the additional SSID.
o
Hide ESSID – Checking this option will hide your wireless network
name from being discovered by wireless client devices scanning for
available wireless networks. This will not disable the additional SSID
and wireless client devices can still connect. It only hides the network
name from being discovered.
o
Turn off wireless radio by schedule – Allows you to assign a time
schedule when the band should be turned on and off.
•
Wireless Security – Allows you to configure the wireless encryption/security for
the additional SSID. See the
TEW-929DRU
"How to choose the type of wireless security" and
31