Table of Contents
Advertisement
TRENDnet User's Guide
Click OK at the bottom to add the AP and assign the controller AP default settings,
otherwise modify the desired parameters first.
Remove access points from the controller
Configuration > Access Points
Once APs are added to the controller, they must be managed and configured through
the controller and can no longer be managed individually. APs must be
removed/disconnected from the controller or reset to default in order to regain
individual AP management access. When APs are removed from the controller, APs are
automatically reset to their factory default settings.
To remove an AP or multiple APs, check the APs you would like to remove in the left
column (The top check box will select all APs in the list), then click Remove. When
prompted, click Yes to confirm removal of the selected APs.
© Copyright 2017 TRENDnet. All Rights Reserved.
TEW-755AP2KAC / TEW-821DAP2KAC
Simultaneously upgrade firmware for multiple access points
Configuration > Access Points
First, make sure you have downloaded the correct firmware for your APs and unzipped
to your local drive. The firmware file for the APs will have a .bin extension.
To simultaneously upgrade firmware for multiple APs, check the APs you would like to
upgrade firmware in the left column (The top check box will select all APs in the list),
then click Upload Firmware. When prompted, click Browse or Choose File (depending
your browser) and navigate to the location of the AP firmware (.bin file) and select it.
Once selected, click Upload to start the firmware upgrade process. Wait about 5
minutes for the process to complete.
23
Advertisement
Table of Contents
