Table of Contents
Advertisement
TRENDnet User's Guide
so these ports can be re-assigned as untagged member ports of new VLANs in example
below.
4. To create a new 802.1Q VLAN, under the VLANs section, click Add.
5. Under VID, enter the VLAN ID to assign to the new VLAN (4-4094, VLAN IDs 1-3 are
reserved for use with the default LAN, WAN1, WAN2 interfaces) and set the untagged
VLAN member ports. Example: In the example below, we will create a new VLAN with
VLAN ID: 50 and assign ports 2 as untagged member ports.
© Copyright 2023 TRENDnet. All Rights Reserved.
6. Enter the VLAN IP interface configuration under IP Address and Subnet Mask.
Example: In the example below, we will enter the VLAN 50 interface IP address as
192.168.50.1 and subnet mask 255.255.255.0.
7. Under DHCP Server, click the Mode drop-down list and select Enabled to enable the
DHCP server on the VLAN. Click Apply to save and commit the changes.
Example: In the example below, we will enable the DHCP server on VLAN 50 and leave IP
address range and lease defaults. This will assign a DHCP IP range of 101-199 to ensure
any devices connected to this VLAN obtain IP address information via DHCP.
TEW-929DRU
16
Advertisement
Table of Contents
