Getting Started; Picture Frames - Inserting Or Changing The Battery; Connecting The Power Supply - Hyundai LF 930 SMULTI Instruction Manual

7) GETTING STARTED

7.1 SETTING UP
● Remove the protection foil from the display.
● Set the product on a flat, level surface where it will not slip.
● Do not place any other objects on top of the device.
Note
The device can be damaged if it tips over or falls.
Make sure that the device cannot tip over.

7.2 PICTURE FRAMES - INSERTING OR CHANGING THE BATTERY

● Open the battery compartment (see illustration).
● Insert a type CR2032 button cell battery, observing polarity.
● Remove the contact breaker strip from the battery if present.
● Close the battery compartment. Make sure that the cover doses easily and tightly.
7.3 REMOTE CONTROL
● Open the battery compartment of the remote control.
● Insert a type CR2032 button cell battery, observing polarity.
● Remove the contact breaker strip from the battery if present.
● Close the battery compartment. Make sure that the cover closes easily and tightly.

7.4 CONNECTING THE POWER SUPPLY

● Conned the enclosed power supply unit to a properly installed socket.
● Then connect the lead of the power supply unit to the DC In of the device.
Warning
Only connect the product to a socket that has been approved for the device. The socket
must be installed close to the product and easily accessible.
Do not continue to operate the device if it becomes visibly damaged.
Note
The power supply unit is suitable for mains voltages of 100 - 240 V and therefore can be
used worldwide. Please note that a country-specific adapter may be necessary..
EN - 43
EN