Recordings - Axis V5938 User Manual

AXIS V5938 PTZ Network Camera
The web interface
Speaker test
You can use the speaker test to verify remotely that the speaker works as intended.
Calibrate: You need to calibrate the speaker before its first test. During calibration, the speaker plays a series of test tones that are
registered by the built-in microphone. When you calibrate the speaker, it must be installed in its final position. If you move the
speaker later, or if its surroundings change, for example, if a wall is built or removed, you need to recalibrate the speaker.
Run the test: Play the same series of test tones that were played during calibration, and compare them with the calibration's
registered values.

Recordings

Ongoing recordings: Show all ongoing recordings on the camera.
Start a recording on the camera.
Choose which storage device to save to.
Stop a recording on the camera.
Triggered recordings will end when manually stopped or when the camera is shut down.
Continuous recordings will continue until manually stopped. Even if the camera is shut down, the recording will continue
when the camera starts up again.
Play the recording.
Stop playing the recording.
Show or hide information and options about the recording.
Set export range: If you only want to export part of the recording, enter a time span.
Encrypt: Select to set a password for exported recordings. It will not be possible to open the exported file without the password.
Click to delete a recording.
Export: Export the whole or a part of the recording.
Click to filter the recordings.
From: Show recordings done after a certain point in time.
To: Show recordings up until a certain point in time.
Source : Show recordings based on source. The source refers to the sensor.
Event: Show recordings based on events.
Storage: Show recordings based on storage type.
39