NRS Healthcare M48192 User Instructions page 2

ASSEMBLY/INSTALLATION
1. Fitting to a Divan Bed
Note: We do not recommend fitting this product to
sprung divans unless a suitable risk assessment has
been done.
1.1 Remove the Mattress
Remove the mattress, then place the bed rail board
onto the divan base with the hand rail guide facing
down.
1.2 Assemble the Bed Rail
Slot the hand rail into the hand rail guide.
Note: Make sure the hand rail angles towards the
footboard.
Secure the hand rail with the two E-clips.
Position the bed rail so the user can reach the
handle from a relaxed lying position without having
to stretch.
WARNING: To avoid possible entrapment, you must
always position the product a minimum of 318 mm
from the headboard or footboard.
1.3 Fitting the Straps
Feed the strap through one of the triangular slots
at the hand rail end, then tie a secure knot before
passing the strap under the bed rail board and up
through the rear triangular slot.
The strap buckle should hang down the side of the
bed between 50 to 75 mm.
1.4 Securing the Straps
Loop the strap around the end of the bed board and
back through the slot. The strap should be tight under
the bed-rail board and the bed-rail board should not
slide on the strap.
Feed the strap over the top of the bed and back
underneath the base.
2