Gree GSY09BXAE User Manual page 22

Clean and Maintenance
Cleaning and maintenance of air guide louver
1.Dismantle air guide louver
Pull out the air guide louver forward with
both hands.
(1)Dismantle the left side, hold the connect-
ing rod with the left hand and hold the left
side of air guide louver with the right hand,
pull it out in the direction as the fig shown
(opposite direction of hook opening), to
separate the connecting rod with the left
side of air guide louver.
(2)Dismantle the right side, hold the air
guide louver with one hand, then pinch the
cross-hook slightly with the other hand,
pull it out downward from the left horizontally.
2.Clean air guide louver
Please soak the cloth with warm water with temperature below 45°C, twist it to
wipe the dirty part, then dry and install it according to the steps opposite to the
above; after installation, re-energize the unit until the air guide louver is reset
automatically, then you can use it.
Inspection before and after usage
Checking before use-season
1. Check whether air inlets and air outlets are blocked.
2. Check whether air switch, plug and socket are in good condition.
3. Check whether filter is clean.
4. Check whether mounting bracket for outdoor unit is damaged or corroded.
If yes, please contact dealer.
5. Check whether drainage pipe is damaged.
Checking after use-season
1. Disconnect power supply.
2. Clean filter and indoor unit's panel.
3. Check whether mounting bracket for outdoor unit is damaged or corroded.
If yes, please contact dealer.
Notice for recovery
1. Many packing materials are recyclable materials.
Please dispose them in appropriate recycling unit.
2. If you want to dispose the air conditioner, please contact local dealer or
consultant service center for the correct disposal method.
Hook
18
Cross-hook