Delta Electronics VFD S 115V Series User Manual page 90

Display
(Pr.0-04=d1)
Counter Trigger Signal
Multi-function Input Terminal
Preliminary Counter Value Attained Output
(Pr. 3-04=d3)
(Pr. 3-05 to Pr. 3-06=d15)
Terminal Count Value Attained Output
(Pr.3-03=d5)
(Pr.3-05 to Pr.3-06=d14)
3-05 Multi-function Output Terminal 1 (Photocoupler output)
3-06
Multi-function Output Terminal 2 (relay output)
Settings d0 to d18
Setting
d0 No Function
d1 AC Drive Operational
Master Frequency Attained
d2
d3 Zero Speed
d4 Over Torque Detection
d5 Base-Block (B.B.) Indication the output will be activated when the output of the AC
d6 Low-Voltage Indication
d7 Operation Mode Indication
d8 Fault Indication
d9 Desired Frequency Attained the output will be activated when the desired frequency
Revision August 2008, SE09, SW V2.61
TRG
Function
the output terminal will be activated when the drive is
running.
the output will be activated when the AC drive attains
Maximum Output Frequency.
the output will be activated when Command Frequency
is lower than the Minimum Output Frequency.
the output will be activated as long as the over-torque is
detected. Pr.6-04 determines the Over-Torque detection
level.
drive is shut off by external Baseblock.
the output will be activated when low voltage is detected.
the output will be activated when the operation of the AC
drive is controlled by External Control Terminals.
the output will be activated when faults occur (oc, ov,
oH, oL, oL1, EF, cF3, HPF, ocA, ocd, ocn, GF).
(Pr.3-02)is attained.
Chapter 5 Parameters|VFD-S Series
2ms
The width of trigger signal
should not be less than
2ms(<250 Hz)
Factory Setting: d1
Factory Setting: d8
Description
2ms
5-33