Table of Contents
Advertisement
38
en | (Optional) Canting the Camera
12
(Optional) Canting the Camera
MIC IP ultra 7100i cameras have on-site canting functionality.
Installers can adjust the camera from an upright position to a canted position (35º angle) if
necessary. In this position, the field of view (FOV) of the camera includes the scene directly
beneath the camera.
When you select the mounting location for the camera, make sure that the location gives the
necessary clearance for the camera head to pan.
Installation
Camera only
Camera + illuminator
You cannot install a canted unit in inverted orientation (with the camera head down). The tilt
limits of the camera prevent correct operation in inverted and canted orientation.
Warning!
Risk of bodily injury.
!
Unplug the device from its power source before canting the device. After removing the screws
from the yoke arms, support the camera head so that it doesn't tilt downward unexpectedly
and pinch fingers or other body parts.
Notice!
Risk of damage to the camera
Do not, under any circumstances, cant the camera while the camera is on its side. Cant the
camera from an upright position only, in order to prevent screws or other objects from falling
into the open spaces in the arms when the yoke caps are removed.
Figure 12.1: Do NOT allow screws or other objects to fall inside the camera.
Warning!
Risk of bodily injury
!
Do not put a canted (35°) camera in an upright position on the camera base or on an
unsecured DCA. In this position, the camera can fall over and can cause injury or be damaged.
Put the canted camera on its side until installation.
2019-12 | 1.2 |
Clearance radius required
200 mm (7.9 in.)
280 mm (11 in.)
Installation Manual
MIC IP ultra 7100i │ MIC IP starlight 7100i
Bosch Security Systems
Advertisement
Table of Contents
