Adjusting Backlight Brightness; Enabling/Disabling Adaptive Intelligent Recovery - Honeywell TH6320ZW2003 User Manual

Adjusting backlight brightness

When the thermostat is in idle mode, you can
adjust how bright you'd like the screen. You
can choose a brightness level from 00 (display
backlight is off, which is the default) up to 05
(maximum brightness). To adjust backlight
brightness, follow the steps below.
1 Touch Menu on the thermostat home screen.
2 Touch the
BRIGHTNESS, then touch Select.
3 Touch or
which will change immediately.
Touch Done to confirm.
4
NOTE: This setting is only available if thermostat
is powered by 24 VAC. This setting only applies
to times when thermostat is not touched. When
adjusting settings thermostat is always at full
brightness.

Enabling/disabling Adaptive Intelligent Recovery

Over time, your T6 Pro Z-Wave thermostat will
learn how long it takes your system to reach the
desired temperature. It can then turn on your
heating or cooling equipment at the right time to
make sure your home is comfortable by the time
you expect. This feature is enabled by default. To
disable it, follow the steps below.
1 Touch Menu on the thermostat home screen.
2 Touch the
RECOVERY, then touch Select.
3 Touch the
RECOVERY ON or RECOVERY OFF, then
touch Done to confirm.
When Adaptive Intelligent Recovery is active,
you'll see the recovery symbol in the upper-right
corner of the thermostat screen.
or arrows until you see
to adjust the brightness level,
or arrows until you see
or arrows to select
Back
Back
15
Done Cancel
Select
Done
Cancel
Select
AM Recovery
Following Schedule
Mode Fan
Heat Auto
Away Home Sleep
Mode Menu Fan
Recovery