Table of Contents
Advertisement
9. TROUBLE DIAGNOSIS
9-1. Faulty Start (F/R lights OFF , F-PCB Power OFF)
Power cord or Fuse
is disconnected ?
1'st power of SMPS
Main PCB Fuse is
disconnected?
(DC12V/14.5V/5V) on
Main PCB is OK?
Wire connection
of F-PCB is OK?
Checkup and connect
F-PCB wires.
※ How to replace Front PCB
1) Insert a flat tip driver into the left down groove of panel frame and snap it out smoothly.
2) Separate 2 housings of 10P / 7P from Front PCB. (Do not hold only wires to pull out.)
3) Unscrew (7 points) to remove Front PCB.
* Follow the reverse order when assembling.
Start
N
is on?
Y
N
Voltage
※ Refer to the 5-1.
(Power circuit diagram)
Y
N
Y
N
Y
N
Y
43
Change the Main Fuse
(AC250V 15A)
(In the left side of
machine compartment)
Check power Cord connection
from machine compartment and
to CN1 of M-PCB.
Change the Fuse
(AC250V 3.15A)
(on the Main PCB)
Change Main PCB
Change F-PCB AS.
Advertisement
Table of Contents
