Appearance; Installation - PR XRLED 3500-W Framing Manual

●To avoid sunlight or other light penetrating into the head via the front lens, resulting in high temperature internally
causing damages to the projector. Before power-off, please use Tilt channel to move the head and make it facing
downward.
Do not use alcohol or other organic solvent to clean the housing to avoid damage.
●
Do not use any solvent with chemical elements to clean color filters or hot mirror.
●
LUBRICATION
●
To ensure smooth movement of gobos and zoom and focus lens, it's advised rotators' bearings and 2 sliding bars for zoom and
focus lens be lubricated every 2 months. High quality and high temperature lubricant/grease is advised..
TROUBLESHOOTING
●
PROBLEM
The projector can't be switched on
The projector can be switched on , but the LED
lamp's brightness can't be controlled
The projector can be switched on normally, but
not controlled by the DMX controller
The beam is not bright and its brightness
decreases sharply
The project image appears to have a halo
Heavily Defective Beam

3.APPEARANCE

4. INSTALLATION

RIGGING
●
During transportation, please lock the projector well; Before the use of projector please unlock the head. It's forbidden to run the
projector without unlock Pan and Tilt
Check if the fuse is burned

Check if the power cord is connected well

Check if the switching power supply is bad or not connected well. A

professional technician is required for the repair
Check if the control board is connected well. .A professional technician

is required for the repair
Check if the LED driver board is connected well. A professional

technician is required for the repair
Make sure that the fixture's start address is right

Replace or repair the XLR signal cable.

Make sure the fans are working well or fans and their shields are not blocked

by dust.
Makesurethat theinternal optics is clean.

Carefully clean the LED lamp, optical lenses and other components.

Check if lens are in good condition(not cracked)

Clean dust or grease on the lens.

5
ACTION
HEAD
ARM
BASE