Table of Contents
Advertisement
TO SET UPDIMMER CURVEAND LED REFRESH FREQUENCY
●
A projector has 4 gamma dimmer curves: gamma 2.0, gamma 2.2, gamma 2.4 and gamma 2.6.
It has 8 LED refresh frequency: LED refresh frequency 1200Hz, LED refresh frequency 2400Hz, LED refresh frequency 4800Hz,
LED refresh frequency 10000Hz, LED refresh frequency 12000Hz, LED refresh frequency 15000Hz, LED refresh frequency
20000Hz and LED refresh frequency 25000Hz.
It has fast, medium and slow dimmer speeds.
Its setups are as follows:
1.
Hold the OK button for more than 3s to unlock the control panel and then push
"Option Settings".
2.
Select "Dimmer Settings" and select any mode of gamma curve /LED frequency /dimmer speed for adjustment.
FAN SPEED MODES
●
It has standard and theater modes. Theater mode is quiet mode.
Its setups are as follows:
1.
Hold the OK button for more than 3s to unlock the control panel and then push
"Option Settings".
2.
Select either of Standard and theater modes after the menu of Fan Settings.
PROJECTOR TYPE
●
It has 3 modes of moving head light, fixed focus profile light and zoom profile light.
For moving head light: linear zoom 5
For fixed focus profile light, it has 6 beam angles: 5°、 10°、 19°、 26°、 36°、 50°. After the beam angle selected, zoom lens can't
move and the light spot can be focused via focus lens;
For zoom profile light, it has 3 bean angle ranges: 5-15°、15-35°、35-50°. If the beam angle range selected, zoom lens can
move in the exact range accordingly and the light spot be focused via focus lens.
For fixed focus profile light and zoom profile light, it can enter into quiet theater mode automatically.
The setups are as follows:
1.
Hold OK key for more than 3s to unlock control panel. After unlocking the control panel, push
menus and select "Options Settings"
2.
Select the projector type after entering into the menu of "Light Type"
AUTO-FOCUS SETUP
●
A projector has auto-focus function for the distance ranges of 5m,10m,15m and 20m respectively. While any of Iris, Framing Blade,
Fixed gobo wheel and Rotating Gobo Wheel is in use, Auto-Focus channel for specified distance can automatically focus the image.
Then use Auto-Focus Calibration channel to fine tune the focused image. Priority sequence: Rotating gobo wheel>Fixed gobo
wheel>Iris>Framing blades . The proposal is for the people to engage in the
BRIGHTNESS CALIBRATION
●
For brightness calibration function, a controller can be used on the projectors in a DMX chain or a projector be done individually.
After running for some time, the projectors need to be recalibrated in brightness for conformity with the help of LED brightness
calibration channel via controller. The function has the following characteristics:
1.
LED brightness calibration channel has 50 levels for adjustment with each level meaning power consumption decreases by 1%.
2.
Calibration can be done on projectors in a DMX chain or a single one. After calibration done on a lot of projectors in a DMX
chain, it can be done individually also if needed.
3.
To avoid erroneous operation, after the fader of a DMX controller is at proper place for LED BRIGHTNESS CALIBRATION
channel, the fader for channel of LED BRIGHTNESS CALIBRATION CONFIRMATION channel should be at right DMX
value range to save parameters. The calibration is completed after the desired parameters are store d into the projectors.
° -50 °, standard fan mode ;
► button to enter into the menus and select
► button to enter into the menus and select
10
►button t o enter into operation
Advertisement
Table of Contents
