PR XRLED 3500-W Framing Manual page 9

.The DMX address can be set via RDM protocol if control panel is not convenient.
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1. Enter into the projector's menu. Select the menu "Config Settigns" via the keys of
Select DMX control Mode---- Wireless First (Note: Do not select XLR ONLY). The DMX wireless control
2.
function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it, Press
"Enter" for the menu of Unlink Wireless under the upper level menu of Config Settigns.
STAND-ALONE MODE
●
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
MASTER/SLAVE MODE
●
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
fixture's DMX output to the third fixture's DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture's DMX output to a DMX terminator. Set 1
StartAddresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master'and Slaves'operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode( It is advised the number of projectors in a DMX chain is 32 at
maximum)
TO SET UP COLOR TEMPEARATUEAND COLOR MACRO
●
A projector has 7 color temperature macros and 89 standard color macros. Color temperatures are for respective
2700K,3000K,3500K,4000K,4500K,5000K and 5700K. Under the DMX channel of CMY macro, color macro and its color
temperature macro can be selected.
st projector as the master and others are Slaves.
9
▲ and ▼