PR XRLED 3500-W Framing Manual page 6

Take 2 clamps and 1 safety cords out from the package and mount 2 clamps on the underside of fixture with 4 retainers attached to
each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the WARNING on the underside of
the base as shown above) Always ensure that the projector is firmly anchored to avoid vibration and slipping whilst functioning.
Always ensure that the structure that you are going to mount the projector is secure and is strong enough to support the weight of the
fixture.
WARNING:
The projector MUST be lifted or carried by the HANDLES instead of clamps.
●
.For safety the safety cord should afford 10 times the Projector's weight.
●
POWER CONNECTIONS
●
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
SAFETY CORD
6
WARMING
Please run safety cord through
the safety hole circled in the
diagram for safety
Note:
1. the distance between the
foot of the base and the front
lens cover(the head facing
downward)
2. the distance between
mounting truss and the front
lens cover( the head facing
downward)
3. The maximum diameter of
the rotating head ( minimum
spacing between fixtures)