Page 1
LED Studio 3500D LED Studio 3500T PR-3500D PR-3500T This product manual contains important information about the safe installation and use of this lighting fixture. Please read and follow these instructions carefully and keep this manual in a safe place for future reference.
INDEX SAFE USAGE OF THE LIGHTING FIXTURE INSTALLING THE LIGHTING FIXTURE CONTROL SYSTEM AND POWER CONNECTIONS DMX TERMINATOR SETUP OPTIONS- LIGHTING FIXTURE CONFIGURATION TO SET THE DMX START ADDRESS OPERATION MENU DMX PROTOCOL INDICATION OF LED DISPLAY MAINTENANCE TROUBLESHOOTING TECHNICAL DATA ELECTRICAL DIAGRAM COMPONENT ORDER CODES Please note that as part of our ongoing commitment to continuous product development, specifications are subject to change without notice.
SAFE USAGE OF THE LIGHTING FIXTURE SAFE USAGE OF THE LIGHTING FIXTURE When unpacking and before disposing of the carton, check there is no transportation damage before using the lighting fixture. When unpacking and before disposing of the carton, check there is no transportation damage before using the lighting fixture. When unpacking and before disposing of the carton, check there is no transportation damage before using the lighting fixture.
INSTALL THE LIGHTING FIXTURE When the lighting fixture is used, as the right figure above, unfold the support to certain angle and put the lighting fixture onto a flat surface. Make sure it is steady. When the lighting fixture is used at a high place, as the left figure above, fold the support, turn it round to the top of the lighting fixture, connect a lamp hook to the mounting hole reserved in the support by screws, and then hang the hook to a high place.
The connections are as the figure below. DMX TERMINATOR In the Controller mode, at the last fixture in the chain, the DMX output has to be connected with a DMX terminator. This prevents electrical noise from disturbing and corrupting the DMX control signals. The DMX terminator is simply an XLR connector with a 120Ω...
SETUP OPTIONS-LIGHTING FIXTURE CONFIGURATION To browse through or change a fixture’s configuration, after ENTER button has been pressed for about 3 seconds, the display of AddR means the entrance of the menu. To set or browse through a fixture’s settings, press buttons of UP and DOWN. After button ENTER is pressed, a sub-menu is entered showing current parameters while indication flashing.
DMX PROTOCOL 1 Channel Mode Channel FUNCTION DESCRIPTION Dimmer 000-255 Dimming 4 Channel Mode Channel FUNCTION DESCRIPTION The first part Dimmer 000-255 Dimming The second part Dimmer 000-255 Dimming The third part Dimmer 000-255 Dimming The forth part Dimmer 000-255 Dimming INDICATION OF LED CHARACTER DMX signal OK...
MAINTENANCE To prolong the life of the lighting fixture, it is very important to do the maintenance work. Cooling fans must be cleaned once every 15days and external lens cleaned periodically for an optimum light output. DO NOT USE ANY SOLVENT CONTAINING CHEMICAL ELEMENT.
COMPONENT ORDER CODES NAME PART NO. QUANTITY REMARK 192010134 Power Switch 10W LED White 150020255 CT3200K for PR-3500T 10W LED White 150020252 CT5500K for PR-3500D 230060309 PR-3500 Control Board(W) 11/12...
Page 12
PR LIGHTING LTD. PR New Hi-tech Science Park, 1582 Xingye Avenue Nancun Panyu, Guangzhou, 511442 China TEL: +86-20-3995 2888 FAX: +86-20-3995 2330 P/N: 320020125A Version:20140711 12/12...