Safetyand Warnings - PR XRLED 3500-W Framing Manual

1. SAFETYAND WARNINGS

Before a projector's installation, power-on, operation and maintenance, please carefully read
The following safety signs are used in the user manual.
User
Warning
Manual
● When unpacking , check if there is transportation damage before using the projector. Should there be any
damage caused by transportation, consult your dealer and do not use it.
●The manufacture is not responsible for loss caused by the user not following the manual or changing the
projector as he/she likes.
●Please be noted that the damage caused by changing the projector at will is not warranted.
● Do not hesitate to contact the dealer or the manufacturer if any questions or advice.
● The projector is for indoor use only, IP20.
● Use only in dry locations. Keep this unit away from rain and moisture, excessive heat, humidity and dust. Do
not allow contact with water or any other liquids.
●The projector should be kept away from high temperature, fire, electrical surge, vibration and strong light while
being operated.
●The projector is only intended for installation, operation and maintenance by qualified personnel. And the
operation must strictly follow the procedures in the manual.
●The projector is not for a user for any replacements and the user shouldn't open the projector for repair and
maintenance.
Don't look straightly into the light sources especially for epileptics, otherwise eyes will be burned..
●
Do not connect this device to any type of dimmer pack.
●
●If the lamp, lens and screen protective cover of the a lighting fixture have obvious damage, i.e., to the extent that
it hurts the performance like cracking or deformation. Please stop use it and replace them with the original parts,
otherwise its performance will be compromised.
● For the location of a lighting fixture, it shouldn't be seen in the distance of less than 4 meters.
Before operation, please confirm that all covers(housing) are on and screws tightened. It's forbidden to use a
●
projector while covers(housing)are off .
Keep the lamp clean and do not touch it with bare hands.
●
While operating it, wear protective items.
●
Any electrical connection must be carried out by a qualified person .
●
Before installation, please confirm the voltage supplied matches what is required for the projector.
●
Each projector must be properly earthed and installed as per related electrical standards.
●
Do not use power cord with its insulator damaged and connect the power cord with other cables.
●
If the projector is not used or under cleaning,, please hold the plug and unplug it. Do not unplug it forcefully or
●
by pulling the power cable.
All power cords must conform to related safety and regulations.
●
the safety information hereinafter!
Goggles
Electrical
shock
3
NOTE
Protective
Gloves
High
Flames
Temperature