Advertisement
3. When the burner has lit, turn the knob to any setting
between HI (high) and SIM (simmer).
• The clicking should stop as soon as the burner
has lit.
• If the burner doesn't light, and/or the clicking
doesn't stop, or the flames are not blue and well-
defined, turn the knob clockwise back to OFF
and see 'Troubleshooting' for advice.
Guidelines for Using the Cooktop Burners
• All burners have the same low turn-down setting (SIM) for gentle simmering (1,300 BTU/hr). Use the SIM
setting for melting chocolate and butter, cooking rice and delicate sauces, simmering soups and stews, and
keeping cooked food hot.
• For cooking that requires especially intense heat (eg searing meat, wok-cooking, stir-frying), use the burners
listed below, as these have a higher maximum output (23,500 BTU/hr for Natural gas) than the other burners
(18,500 BTU/hr for Natural gas).
◦ RGV2-305 / RDV2-305 and RGV2-485GD / RDV2-485GD models: Center burner
◦ RGV2-488/RDV2-488 and RGV2-366/RDV2-366 MODELS: Front left burner or front right burner
◦ All other models: Front left burner
• Never leave the cooktop unattended when in use. Boilover causes smoking and greasy spills that may ignite.
• Never allow flames to extend beyond cookware or curl up its sides. This could discolor and damage the utensil
and you may get burned touching a hot handle.
• Keep handles out of the way. Turn handles so that they don't extend over the edge of the cooktop or another
https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/RGV2-366-N_N/User_Guide_RGV2-366-N_N/05_Cooktop_Use
4. When you have finished cooking, turn the knob
clockwise back to OFF.
• The knob will release and the burner and halo
will go out.
• If you are using LP gas, there may be a slight
'extinction pop' or flash at the flame spreader a
few seconds after the burner has been turned
off. This is normal for LP gas.
Updated: Fri, 08 Sep 2023 23:56:17 GMT
Powered by
2
Advertisement
