Table of Contents
Advertisement
DOK-INDRV*-HMV01******-IT01-EN-P
Rexroth IndraDrive Supply Units HMV01
Arranging the Cooling Units
Avoiding Dripping or Spraying Wa‐
To extend the module bus connection, the accessory RKB0001 is
available. Observe the assignment.
1
Discharge of heated air to cooling unit
2
Interior of control cabinet
3
Conveying direction of heated air in area where air flows off
4
Device in control cabinet
5
Air intake at device
6
Air guide in control cabinet (for liquid cooling, this is also the drip pro‐
tection for the devices beneath)
7
Fan in control cabinet
8
Supply of cooled air from cooling unit
Fig.5-41:
Example of Arrangement for Double-Line Design
Unless the nominal data are reduced, the drive controller may only be operat‐
ed up to a specified maximum ambient temperature. A cooling unit might
therefore be required.
NOTICE
Observe the instructions below.
Due to their operating principle, condensation water is formed when cooling
ter
units are used.
For this reason, observe the following aspects:
Bosch Rexroth AG
Possible damage to the drive controller! Op‐
erational safety of the machine endangered!
59/81
Instructions for Use
Advertisement
Table of Contents
