Vacuum Set Up And Operation - Shop-Vac 92P Series User Manual

CARRIAGE HANDLE FOR METAL TANK
If your vacuum came with a carriage handle, follow these instructions. The carriage handle does not come
standard with all models. You will find one carriage handle and a handle pack containing two side tank
handles, four handle supports and eight screws. Assemble as follows:
1. Take two handle supports and two 1" screws. Place screws through the hole
provided in center of each support.
2. Position the tank, in the upright position, with the inlet facing you. Put the support
assemblies inside the tank, then place the screws through the holes provided on
left side of the tank. Make sure the plastic portion is located inside the tank. Turn
the supports until the back of the supports fit flush against the inside curve of the
tank.
3. Remove any webbing that attaches the tank handles to each other. Take the side
tank handle with the letter L and position it on the outside of the tank where the
support assemblies are installed. The U-shaped cutout on the bottom end of the
handle must face the rear of the tank. Secure the side tank handle to the tank
with the screws in the support assemblies.
4. Repeat steps 1 to 3 using right side of tank and the remaining side tank handle
marked with the letter R.
5. Position metal carriage handle outside of tank and under the tank handles. Be
sure to spread ends of carriage handle when assembling to prevent damage
to tank. Line up holes in ends of carriage handle with holes in bottom of tank
handles. Make sure carriage handle is in the U-shaped cut on the tank handles
(located towards rear of unit). Secure with 1½" screws provided.
BASKET
If your unit came with a basket, insert basket through center of carriage handle and
slide into place. The basket does not come standard with all models.

VACUUM SET UP AND OPERATION

DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct
filters are installed for normal dry or wet pick up operation based on your cleaning
needs. To use the pump feature, refer to the pump set up and operation section.
2. Replace tank cover. Make sure each latch or clamp is secured over the raised area
of the tank cover. Failure to properly secure the latches could cause the tank cover
to release from the tank.
3. Insert machine hose end with locking nut into inlet located in the front of the tank.
Turn locking nut to tighten. Do not over-tighten.
ASSEMBLY (CONT'D.)
–
This equipment incorporates parts such as switches, motors or the
PAGE 7