Automatic Shut Off; Lubrication; Storage; Service - Shop-Vac 92P Series User Manual

Commercial/industrial use wet/dry vacuum
Hide thumbs Also See for 92P Series:
Table of Contents

Advertisement

Available languages

Available languages

AUTOMATIC SUCTION SHUT OFF
The cleaner is equipped with an automatic shut-off feature when picking up liquids. As the level of the liquid
rises, an internal float electrically shuts the unit off when liquid reaches the tank capacity. At this point, the
liquid must be emptied to allow vacuuming to continue. Refer to PUMP SET UP AND OPERATION.
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
Before storing your vacuum the tank should be emptied and cleaned. Never allow liquids to sit in the tank
for any extended period of time. The vacuum should be stored indoors.
Do not attempt to service your Shop-Vac
Refer all other servicing to a qualified service center.
PROBLEM
Parts/accessories
missing
Vacuum cleaner
will not start
Dust discharging
from exhaust
Loss of suction
Static shock
WARNING
DETACHED OR BROKEN, EXPOSING THE MOTOR OR ANY OTHER ELECTRICAL COMPONENTS,
OPERATION SHOULD BE DISCONTINUED IMMEDIATELY TO AVOID PERSONAL INJURY OR
FURTHER DAMAGE TO THE VACUUM. REPAIRS SHOULD BE MADE BEFORE REUSING THE
VACUUM.

LUBRICATION

STORAGE

SERVICE

wet/dry vacuum cleaner beyond that described in this manual.
®

TROUBLESHOOTING

POSSIBLE CAUSES
1. Packed in tank
1. No power at receptacle
2. Defective switch
3. Defective motor
1. Filter not installed/not installed
properly
2. Filter damaged
3. Filter clogged or dust is too fine
4. Filter not functional
1. Loose hose connection
2. Filter clogged
3. Full tank
4. Hole in hose
1. Dry environment
2. Relative humidity of air is low
IF ANY OF THE MOTOR HOUSING PARTS SHOULD BECOME
SOLUTION
1. Check in tank
1. Check for power
2. Contact Shop-Vac
customer service
3. Contact Shop-Vac
customer service
1. Properly install filter
2. Replace filter
3. Use more efficient filter
4. Clean or replace filter
1. Tighten hose connection
2. Clean or replace filter
3. Empty tank
4. Replace hose
1. Add moisture to air (if
practical, use a console
or installed humidifier).
2. This situation is temporary
and does not affect the use
of the vacuum cleaner.
®
®
PAGE 13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

92p600cm

Table of Contents