Set Up And Operation - Shop-Vac SC16 Series User Manual

4. Push the post, located on the unsecured end of the indicator, into the round hole
on the blower port cover.
1. Refer to the ilter installation and maintenance section to make sure the correct ilters are installed for
your cleaning operation.
2. Replace tank cover and apply pressure with thumb to each latch until it snaps tightly into place. Make
sure each latch is clamped securely.
3. Insert machine hose end with locking-nut into inlet located on the front of the tank.
Turn locking nut to tighten. Do not over-tighten.
4. Attach the extension wands to the accessory end of the hose. Twist the wands slightly at each
connection to secure them into place. NOTE: If an elbow grip (not standard on all models) has been
included with your vacuum, it can be placed between the accessory end of hose and the extension
wands for a more comfortable hand grip.
5. Attach one of the cleaning accessories (depending on your cleaning requirements) onto the extension
wands. Twist the accessory slightly to tighten the connection. NOTE: Many more useful tools are
available at your local dealer or the Shop-Vac
6. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
AIRFLOW INDICATOR (PERFORMANCE GAUGE)
(Not standard with all models)
The performance of the vacuum is largely dependent on the air lowing through the unit. The airlow
indicator can help you monitor the airlow. NOTE: It is important to check your filters periodically even if
the airflow indicator does not register that there is a problem. If your filter is not installed properly,
missing the filter retainer or has a hole, the airflow will not reduce and register on the indicator.
These issues could damage the vacuum motor or cause dust to discharge from the exhaust. To use
the indictor, make sure it is installed on the blower port cover. Remove any accessories from the hose and
position the hose end so it is open to the air. Turn the unit on and look to see where the bar on the ilter
indicator is positioned. If the end of the bar is in the green, continue your cleaning operation. If it is in the
yellow, consider reviewing the chart in this section to improve the vacuum's performance. If it is in the red,
turn the unit off and review the chart in this section. It is normal for the bar to move during the cleaning
process due to the accessory or hose being moved across a surface.
PAGE 6
ASSEMBLY (CONT'D.)

SET UP AND OPERATION

®
website.