Installation - ACP RFS12TSW Owner's Manual

Unpacked Oven
 Inspect oven for damage such as dents in door or inside
oven cavity.
 Report any dents or breakage to source of purchase
immediately.
Do not attempt to use oven if damaged.
 Remove all materials from oven interior.
 If oven has been stored in extremely cold area, wait a
few hours before connecting power.
Radio Interference
Microwave operation may cause interference to radio,
television, or a similar oven. Reduce or eliminate
interference by doing the following:
 Clean door and sealing surfaces of oven according to
instructions in Care and Cleaning section.
 Place radio, television, etc as far as possible from
oven.
 Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.
Oven Placement
 Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
 Do not block or obstruct oven filter. Allow access for
cleaning.
 Install oven on level countertop surface.
 Place warning label in a conspicuous place close to
microwave oven.
 Outlet should be located so that plug is accessible
when oven is in place
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
A―For North American (UL/CSA) models, allow at
least 2" (5.1cm) of clearance around top of oven. For
International (50 Hz) models, allow at least 12" (30
cm) f clearance around top of oven. Proper air flow
around oven colls electrical components. With
restricted air flow, oven may not operate properly and
life of electrical parts is reduced.
B―Allow at least 2" (5.1 cm) between air discharge on
back of oven and back wall.
C―Allow at least 2" (5.1cm) of clearance around sides
of oven.
Oven Clearances
Oven Stacking

Oven stacking is allowed using stacking bracket located on
oven back panel top hinge side corner.

Using stacking brackets on back panel of ovens remove
screws from stacking brackets and reattach them to back
panel between both ovens securing them together using
back panel screws.
6

Installation