Table of Contents
Advertisement
7.6
Gearmotor
Remove the casing (A) by
loosening the three screws.
Disassemble the protection
plate (C) by loosening the
screws.
PRIMEA Chapter 07
REV. 02 - Mar. 07
Loosen the two screws and
remove the heater pin (B).
The following are located inside the compartment
protected by the guard:
- Electric motor (A) with gears (B) and (C) for
transmission and timing of the brew group;
- grounds drawer present microswitch (D);
- Brew group present microswitch (E);
- Microswitch (F) - brew group at home posi-
tion;
- Microswitch (G) - brew group at dispensing
position.
Withdraw the gear (C) that meshes with the motor
transmission shaft.
Withdraw the large gear (B).
Pull out the motor (A) complete with transmission
shaft (H).
7/22
Advertisement
Table of Contents
