Page 1
SKF-S25J ( This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there is any technology or software updates on our product.)...
IMPORTANT SAFETY INFORMATION: WARNING:Read all safety warnings, instructions, illustrations and specifications provided with this electric appliance. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. SAFETY INFORMATION This is the safety alert symbol.
Page 3
-farm houses -by clients in hotels,motels and other residential type environments; -Catering industry and similar non-retail industry. ●This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Product specifications: Model No SKF-S25J Rated Voltage AC120V 60Hz Input Power 350W Rated Current Ice production 62lbs/day Ice basket capacity 5lbs Refrigerating R290/24g Shock Protection Type Foam Material Cyclopentane Quick introduction:...
Installation and setup Caution: Installation must be installed by professionals.
Page 6
Warning: The drain of inner tank must be always connected to a floor drain. The drain of internal water tank (Only connect to a floor drain after cleaning, or it must be plugged) Installation requirements Lifting Hazard: It is recommended to have two people move and install the ice maker in order to prevent injury.
Page 7
Prepare for use 1. Carefully remove packing material. Do not use sharp tools that can damage the ice maker. 2. Ensure all components are present. (An assembled filter, 1 drainage pipe and 2 silica plug, drip tray and drip tray cover are a standard on the machine.)
3. Place the ice maker upright on a flat, level surface and plug it in. 4. Clean the ice maker before first use. Connect to water and drain pipe It must be connected connected to tap water. If there is a problem caused by the tap water without a filter, our company will not bear the cost of repairing.
Page 9
Control board (1)Standby: Plug the power cord into the socket will make the machine enter standby mode. (2)Touch “making ice”,”dispense ice”,”clean” icon under standby mode, the selected indicator will blink. (3)Making ice: Touch “Making ice” icon under standby mode or “clean” mode to make the machine start to make ice; Long touch this icon for 2 seconds during “Making ice”...
Page 10
2. Daily cleaning During the working time, more and more scales will precipitate in the water tank. If it is not cleaned in time, it will cause malfunctions. Generally, it needs to be cleaned once a week. Take all nugget ice out, add 10% edible citric acid to the water tank during cleaning, touch the clean icon, it will take about 5min to finish the clean procedure, and then repeatedly rinse with fresh water before using.
Page 11
Take too long to Water pressure Lower water pressure Check the water source make ice Water Water temperature is high Change to a water source of lower temperature temperature Ambient Ambient temperature is too Change to a place of lower temperature temperature high or too low Refrigerant...
Need help?
Do you have a question about the SKF-S25J and is the answer not in the manual?
Questions and answers