Table of Contents
Advertisement
10
G R I D S H I E L D
—
3.2.1 GridShield
01 Lifting a GridShield
3P single-tank recloser
The GridShield 3P recloser is equipped with two
—
brackets that can be attached to its sides. These
02 Lifting GridShield
3SP recloser
brackets serve as a means to lift the recloser.
(compact frame)
It is strongly recommended to use a four-point lift,
—
03 Lifting GridShield
using the loops provided in these brackets (refer
3SP recloser
to figure 1). If the unit is shipped unassembled,
(substation frame)
—
you will find these brackets in one of the shipping
04 Lifting GridShield
boxes. If the substation frames are shipped already
3SP recloser (cross-
arm frame)
assembled, carefully lift the frame off the pallet,
being cautious not to cause any damage to the
poles. Then, position the frame at the desired
location. Afterward, detach the lifting brackets
from the frame and attach them to the recloser
for lifting purposes. It is important to avoid placing
the recloser on an uneven surface to prevent any
potential damage to the open/close indicators.
—
01
—
02
®
3 P/ 3 S P R E C L O S E R
3P (single-tank recloser)
®
3.2.2 GridShield 3SP (three individual poles)
To ensure proper installation of a 3SP recloser,
follow these guidelines:
1.
Lift the site-ready unit using either four-point
lifting points (for compact frame) or the center
lifting point (for cross-arm frame).
2.
If you're dealing with individual poles, you can
use lifting straps. Alternatively, for a wrap-
around frame, lifting straps can also be used.
3.
Refer to the illustrations below for visual
representation.
—
03
—
04
Advertisement
Table of Contents
