Table of Contents
Advertisement
Proline Promass 80 PROFIBUS PA
"
Endress+Hauser
3.3.2
Installing the wall-mount transmitter housing
There are various ways of installing the wall-mount housing:
• Mounted directly on the wall
• Installation in control panel (with separate mounting set, accessories → Page 70)
• Pipe mounting (with separate mounting set, accessories → Page 70)
Caution!
• Make sure that the ambient temperature at the place of the installation does not exceed the per-
missible range (−20° °C to +60°C). Install the device in a shady location. Avoid direct sunlight.
• Always install the wall-mount housing in such a way that the cable entries are pointing down.
Direct wall mounting
1.
Drill the holes as illustrated in Fig. 12.
2.
Remove the cover of the connection compartment (a).
3.
Push the two securing screws (b) through the appropriate bores (c) in the housing.
– Securing screws (M6): max. Ø 6.5 mm (0.26")
– Screw head: max. Ø 10.5 mm (0.41")
4.
Secure the transmitter housing to the wall as indicated.
5.
Screw the cover of the connection compartment (a) firmly onto the housing.
90 (3.54)
Fig. 12:
Direct wall mounting
35 (1.38)
b
c
a
3 Installation
c
192 (7.56)
mm (inch)
A0001130
21
Advertisement
Table of Contents
