Forno FBOEL1358-30 Instruction Manual page 14

4. Child key function
1). When the oven is on standby, touch the "Start" button and hold for 3 seconds. The control panel is
locked.
keys are touched, the child lock icon on the screen blinks and an invalid tone is heard concurrently.
2). When the oven enters the working state, touch the "Start" button and hold it for 3 seconds, the
when touching other keys, if there is no unlock after 3 seconds, return to the current operating state,
touch the "Start" button and hold it for 3 seconds, the child lock will be released, At the same time, the
child lock symbol on the screen disappears
other Settings interface.
5. The alarm function
1). Touch the timer button on the numeric keypad to enter the alarm Settings as shown below:
Alarm the longest allowed to set a time for 12 hours, the alarm with the countdown, display mode
(hours: minutes) and (minutes: seconds), if the setting time is less than 1 hour, then the system shown
in the form of (minutes: seconds), if the set time more than one hour, then the system shown in the
form of (hours: minutes). If you need to set the alarm after 30 minutes, you only need to touch 3 and 0
alarm starts to count down.
Touch the number key3
Touch the number key0
After setting the alarm, enter the alarm countdown. In standby state, the alarm clock is on the digital
tube of the screen. In the running state, the alarm time is not displayed, only the alarm symbol is
displayed
At the end of the countdown, the buzzer rings and the alarm symbol blinks with 00:00 at the same
time. At this time, you can touch any key to cancel the alarm. If there is no touch, the alarm will stop
after one minute, and the alarm icon and 00:00 will stop blinking and disappear
2). Alarm cancellation: just touch the alarm setting button.
Degree, the program gives a rotation signal to the door lock motor, the CAM begins to turn
counterclockwise, when the CAM contact will be left door lock switch (LATch2) press the rear
door lock open, at this time the program gives the door lock motor stop signal.
After the lock is locked, the symbol appears on the screen, and after the lock is unlocked, the
symbol disappears.
Latch1 indicates the lock detection port, latch2 indicates the unlock detection port.
6. Error alarm message
Abnormal Temperature sensor: Err1
In any state, if the temperature sensor is open or short, the oven will give an alarm
and display Err1. In this case, cancel can be performed