Craftsman 247.775890 Owner's Manual page 5

I Rear
2 Bottles
of OII
Hopper"
Chipper
Chute
Discharge Chute
* The hopperis packed
in _e top Insert In
your chipper-shredder
carton.
Figure I
:hlp Bag
Spark Plug Wire
Figure 2
IMPORTANT: This unit is shipped without gasoline
or oil in the engine. After assembly, see
OPERATION section of this manual for proper fuel
and engine oil fill-up.
NOTE: To determine right and left hand sides of your
chipper-shredder, stand behind the-onit with the
engine farthest away from you. See Figure I inset. _
Your chipper-shredder has been completely
assembled at the factory, except for the hopper
assembly, chipper chute, discharge chute and the
catcher bag. These parts are shipped loose in the
carton. A pair of safety glasses and two bottles of oil
are also included in the carton.
Remove From Carton
• Cut the comers of the carton. Remove all
packing inserts. Remove all loose parts
including owner's manual. See Figure 1,
• Roll chipper-shredder out of the carton.
• Make certain all parts and literature have been
removed before the carton is discarded.
Loose Parts
(Refer to Figure 1.)
a. Hopper Assembly
b. Discharge Chute
c. Chipper Chute
d. Leaf Bag, chip bag
e. Bottle of Oil (2)
f. Safety Glasses (not shown in Figure 1)
g. Owner's Manual (not shown in Figure 1)
Tools Required
1. 1/2" or adjustable wrenches
2. 7/16" or,adjustable wrencbes
3. 9/16 _ or adjustable _ncl_es "_
4. Funnel
Disconnecting Spark Plug
• Disconnect the spark plug wire and move it
away from the spark plug before assembling the
chippar-shredder. See Figure 2.
Attaching Discharge Chute
• Remove the wing knobs from each side of the
discharge opening on the chipper-shredder.
• Using two 7/16" wrenches, remove hex lock nut,
two spacers, and the he]( bolt from top of the
housing assembly. For easy assembly, do not
remove the second spacer from the hex bolt.
• Place the discharge chute in position on the
discharge opening as shown in step I in Figure
3. Insert hex bolt and spacer through hinge on
discharge chute and housing (spacer fits inside
of hinge). See Figure 3 inset A.