DeLonghi ESAM04110S Manual page 13

2
4
1
1
3
5
2
2
1
4
6
1
3
3
2
5
7
2
4
4
3
6
8
3
5
5
4
7
9
4
6
6
5
8
10
5
7
7
6
9
11
6
8
8
7
10
7
9
9
8
11
8
10
10
9
9
11
11
10
10
11
11
19. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot
The coffee is weak or not
creamy enough.
There is an unusual
noise and the lights
flash alternately
The lights
alternately
The lights flash
The light (B13) is on
steadily
The light flashes
The lights flash
alternately
POSSIBLE CAUSE
The cups were not preheated.
The infuser has cooled down because 2/3 mi-
nutes have elapsed since the last coffee was
made.
The coffee is ground too coarsely.
The coffee is unsuitable.
The infuser has not been
replaced after cleaning
flash The coffee maker has
just been turned on, the
infuser is not inserted cor-
rectly and the service door
is not correctly closed.
The pre-ground coffee
funnel is clogged
The infuser has not been
replaced after cleaning.
The inside of the appliance
is very dirty
The service door is open
The coffee maker has been
switched on with the steam
knob in the open position
SOLUTION
Warm the cups by rinsing them with hot water
(N.B. you can use the hot water function).
Before making coffee, heat the infuser (A20) by
pressing the
Turn the grinding adjustment knob (A1) one click
anticlockwise towards "1" while the coffee mill is in
operation (fig. 7). Continue one click at a time until
coffee delivery is satisfactory. The effect is only visi-
ble after delivering 2 coffees (see the section "10.3
Adjusting the coffee mill").
Use pre-ground coffee for espresso coffee makers
18
Leave the service door (A16) closed
and the infuser (A20) out of the
coffee maker. Press the
or (B5) buttons toge-
ther until the four lights go off.
Only when all four lights are off
can the door be opened and the
infuser inserted.
Press the word PUSH on the infuser
(A20)until it clicks into place.
Make sure the two red buttons
have snapped out.
Close the service door and turn the
appliance on again
Empty the funnel (A8) with the
help of a brush as described in the
section "13.7 Cleaning the pre-
ground coffee funnel".
Insert the infuser (A20) as descri-
bed in the paragraph "13.8 Clea-
ning the infuser"
Clean the appliance thoroughly
If you cannot close the door (A16),
make sure the infuser (A20) is cor-
rectly inserted
You must turn the steam/hot
water knob (B10) to position 0
button (B14).
(B3)