Gaggenau AC270101 User Manual And Installation Instructions page 38

en Installation instructions
¡ Do not connect the appliance to the power supply
during installation.
¡ Ensure that the protection against contact is guaran-
teed during installation.
¡ Only a licensed professional may connect appli-
ances without plugs. They are subject to the require-
ments of the local electricity provider.
16.7 Information on the installation situation
¡ Install this appliance on the kitchen ceiling or a
stable suspended ceiling.
¡ To install additional special accessory parts, ob-
serve the enclosed installation instructions.
¡ Recommended ceiling height up to 3.50 m.
¡ The appliance finds it more difficult to draw in the
cooking vapours the further away they are from the
hotplate. For optimum performance, a maximum dis-
tance of 1500 mm is recommended.
¡ The width of the extractor hood must correspond at
least with the width of the hob.
¡ To optimally detect the cooking vapours, install the
appliance in the middle of the hob.
¡ When securing cables, ensure that the maximum
distance between the frame cover and the top edge
of the appliance is 1.20 m.
16.8 Installation
Checking the ceiling
Check whether the ceiling is horizontal and ad-
1.
equately load-bearing.
The maximum weight of the appliance is 80 kg.
Do not fit the appliance directly onto plasterboard
(or similar lightweight materials) in a suspended
ceiling.
2. Drill the hole depth in accordance with the length of
the screws.
Use the enclosed screws are suitable only for con-
3.
crete ceilings.
Install the appliance with a fixing material which is
4.
sufficiently stable and has been adjusted accord-
ingly for both the structural conditions and the
weight of the appliance.
Check the cut-out area for existing cables of other
5.
appliances.
Preparing the ceiling
Cover the hob to prevent damage.
1.
Determine the position of the frame and thereby the
2.
middle based on the position of the hob.
Ensure that there are no electrical wires, gas pipes
3.
or water pipes in the area where holes are to be
drilled.
Drill four holes with a diameter of 6 mm for the fix-
4.
ing.
Drill the hole depth in accordance with the length of
5.
the screws.
38
Fitting the frame
Screw the two opposite screws into the ceiling until
1.
they protrude out of the ceiling by approx. 7 mm.
Note the correct position of the screws and the
frame.
Guide the frame through the screws on the ceiling.
2.
Move the frame so that the screws lock into place in
3.
the key hole openings and can be screwed in
tightly.
Align the frame and use two screws to secure it in
4.
place.
Place a scissor lift table or another suitable device
5.
under the appliance.
Do not place the scissor lift table on the hob.
Position the appliance on the scissor lift table so
6.
that the appliance is on the frame.
Do not place the appliance on the grease filters as
these could be damaged.
Leave a gap of at least 700 mm between the hob
7.
and the lower edge of the appliance.
When securing cables, ensure that the maximum
distance between the frame cover and the top edge
of the appliance is 1.20 m.
Connecting the appliance
Pull the protective tube over the on-site cable.
1.
900 mm
492 mm