Post-Installation Checks - Raymarine Evolution EV-2 Installation Instructions Manual

12.1 Post-installation checks

These checks should be carried out after installation, and prior to the commissioning of the autopilot
system.
1. Switch on power to the autopilot system and associated equipment.
• Drive interface unit
• Autopilot controller
• DeviceNet backbone (if this has its own power supply)
2. Check that the autopilot controller powers up. If the display is blank press and hold the Power
button for 2 seconds.
3. Check the EV-2 and Pilot Controller display have the latest software. Visit
www.raymarine.com/software
display to update the software on these autopilot system components. The web page also
contains instructions on how to update your software.
4. Check the display for error messages that could indicate a problem with the installation.
5. Check the LED status indications for the EV-2. Refer to:
6. If the fault persists and cannot be rectified, contact your dealer or Raymarine product support.
62
to obtain the latest software, and then use your multifunction
p.69 — LED indications — EV-2