Raymarine Evolution EV-2 Installation Instructions Manual page 41

1. Use the Mounting bracket template (87170) to drill 3 pilot holes in the vertical mounting surface.
Secure the mounting bracket to the surface using the supplied screws.
2. Place the small sealing ring in the groove located on the bottom of the Mounting tray.
3. Secure the tray to the bracket using 3 of the supplied screws, in the positions indicated in the
illustration above.
4. Place the large sealing ring into the groove on the upper side of the Mounting tray.
5. Pull the SeaTalkng ® and DeviceNet cables through the mounting surface hole and the Mounting
tray. Plug in the cable connectors on the underside of the unit and secure as follows:
• SeaTalkng ® cable — secure by rotating the locking collar clockwise 2 clicks.
• DeviceNet cable — secure by turning the cable connector's collar clockwise until tight.
6. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
The unit must be mounted with the LED 'arrow' in parallel alignment with the longitudinal axis
(centerline) of the vessel and be pointing towards the vessel's bow.
7. Place the Mounting trim over the unit slightly offset, and then twist the Mounting trim clockwise
until it locks into position.
Installation 41