Raymarine Evolution EV-2 Installation Instructions Manual page 39

3. Position the Mounting tray on top of the Riser.
4. Secure the Mounting tray to the Riser using 3x supplied fixings.
5. Place the large sealing ring into the groove on the upper side of the Mounting tray.
6. Pull the SeaTalkng ® and DeviceNet cables through the Riser and Mounting tray. Plug in both
cable connectors on the underside of the unit. Secure the SeaTalkng ® cable by rotating the
locking collar clockwise 2 clicks.
Important:
If there is not enough space in the riser to accommodate the cables and to plug the SeaTalkng ®
or DeviceNet spur cables into the unit, you may need to obtain a SeaTalkng ® spur cable with a
right-angled elbow connector (A06081), or a right-angled elbow adaptor (A06077).
7. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
The unit must be mounted with the LED 'arrow' in parallel alignment with the longitudinal axis
(centerline) of the vessel and be pointing towards the vessel's bow.
8. Place the Mounting trim over the unit slightly offset, and then twist the Mounting trim clockwise
until it locks into position.
Installation 39