Drive Interface Unit Connection - Volvo Penta Evc; Power Connection - Volvo Penta Evc Interface - Raymarine Evolution EV-2 Installation Instructions Manual

10.2 Drive interface unit connection — Volvo Penta EVC
The EV-2 connects to a Volvo Penta EVC drive interface unit via DeviceNet connections.
1. 12 V dc power supply (providing power to SeaTalkng ®.)
2. EV-2
3. Autopilot controller
4. DeviceNet adaptor cables (female) (as supplied with Raymarine DeviceNet cable kit.)
5. 12 V dc power supply (providing power to the Volvo Penta EVC interface unit.)
6. SeaTalkng ® 5–way block
7. Volvo Penta EVC drive interface unit (available separately.)
8. Dedicated SeaTalkng ® backbone (providing power to the Volvo Penta EVC drive interface.)
9. Engine CAN bus
Power connection — Volvo Penta EVC interface
The EVC interface unit requires a 12 V power source, which must be provided to the EVC unit via
a battery.
• If your vessel has a 24 V supply a suitable voltage convertor is required.
• The power source must be protected by a 5 A fuse or a circuit breaker providing equivalent
protection.
• The EVC interface unit must be connected to a 12 V dc power source via a dedicated SeaTalkng ®
backbone.
Drive interface unit connections 55