Installation; Surface Mounting The Ev-2 - Raymarine Evolution EV-2 Installation Instructions Manual

8.1 EV-2 Installation

Surface mounting the EV-2

The supplied Deck mounting kit is used to surface mount the unit.
Ensure that the chosen location meets the product's location requirements; refer to:
p.32 — Location requirements — EV–1 and EV–2
Important:
The installation must only be performed with the vessel either on a hard standing, or tied-up
alongside a pontoon or berth.
1. Using the Mounting tray template (87170), drill 4 holes in the mounting surface, plus a 22 mm (7/8
in) hole for the SeaTalkng ® cable.
2. Place the small sealing ring in the groove located on the bottom of the Mounting tray.
3. Secure the tray to the mounting surface using the 4 x fixings, supplied.
4. Place the large sealing ring into the groove on the upper side of the Mounting tray.
5. Pull the SeaTalkng ® and DeviceNet cables through the mounting surface hole and the Mounting
tray. Plug in the cable connectors on the underside of the unit and secure as follows:
• SeaTalkng ® cable — secure by rotating the locking collar clockwise 2 clicks.
• DeviceNet cable — secure by turning the cable connector's collar clockwise until tight.
36