Table of Contents
Advertisement
Delete Stitches or Letters
To delete a stitch in the program, select the stitch with the cursor by touching the arrow icons and then touch the delete
icon (E).
To delete the whole program, you can either touch and hold Delete (long touch) or move the cursor to the left of the first
position and touch the delete icon. A pop-up will appear asking you to verify the deletion. Select Yes or No with a touch
and confirm with OK.
Add Commands
The commands FIX, STOP and Thread Cut can be added to
the program. Each command takes one memory space in the
program. To add any of the above functions to your program
just press the corresponding function on the Function Panel
(see page 18).
Note: If autofix is activated on your machine you do not need to add a
FIX at the beginning of the program.
Join Two Stitch Programs into One
You can add a previously saved program to a new one in
Programming Mode. Touch the Stitch/Font Menu icon, select
My Stitches and the program you wish to add. The program
will be inserted in Programming Mode to the right of the
cursor.
Adjust a Single Stitch or Letter
To adjust the settings of a single stitch in a program you must
select the stitch in Programming Mode. You can adjust the
stitch width, stitch length, density or mirror the stitch. The
settings for the selected stitch are shown on the TouchScreen.
Touch Alt to toggle between different settings.
Adjust the Entire Stitch Program
Adjustments that affect the whole program and not just single
stitches, are done in Sewing Mode. Touch the PROG icon
to leave Programming Mode and switch to Sewing Mode. In
Sewing Mode you can adjust the width and length or mirror
the whole program.
There are a few things you need to know when adjusting the
stitch program in Sewing Mode:
The adjustments you make to the program in Sewing Mode
can be saved to My Stitches. However, these adjustments
cannot be brought back to Programming Mode. If you have
made adjustments in Sewing Mode and touch the PROG icon
to go back to Programming Mode, these adjustments will be
cancelled. This will also happen if you load a saved program
from My Stitches to Programming Mode.
If you have programmed a STOP, FIX or Thread Cut and
mirror the program end to end, the commands will change
positions just as the stitches. This might not give the result you
intended.
Add commands
Adjust a single stitch or letter
OPERATING YOUR SEWING MACHINE – 23
Advertisement
Table of Contents
