Table of Contents
Advertisement
Main Motor Overload
If you are sewing on very heavy fabric or if the machine is blocked
when sewing, the main motor can get overloaded. The pop-up
message will close when the main motor and power supply is
secure.
Sensor One-Step Buttonhole Foot Line Up -
"Adjust White Area to White Line"
When you insert the fabric for sewing a buttonhole, the wheel
of the Sensor One-Step Buttonhole Foot might move. A pop-up
message prompts you to line up the white area with the white line.
Line up the white areas and close the pop-up message with OK.
Sensor One-Step Buttonhole Foot Connected
The Sensor One-Step Buttonhole Foot can only be used for the
buttonhole stitches recommended for the foot. If the Sensor One-
Step Buttonhole Foot is connected and you select a stitch that is
not possible to sew with the foot, this message will appear when
you start to sew. Remove the foot or select a buttonhole that can be
sewn with the Sensor One-Step Buttonhole Foot. Close the pop-up
message with OK.
Restart the Buttonhole?
If you are sewing a buttonhole and stop to adjust the length settings
you will get this question once you start sewing again. If you select
"", the machine will restart and sew the buttonhole from the
beginning with the new settings. If you select "", the change will
be cancelled and the machine will continue sewing the rest of the
buttonhole with the previous settings.
The Stitch Cannot be Programmed
This message is shown if you try to program or add a buttonhole,
bartack or Automatic Tapering stitches or the sew on button stitch
to a program. All stitches in your sewing machine are programmable
except for these. Close the pop-up message with OK.
POP-UP MESSAGES – 41
Advertisement
Table of Contents
