Table of Contents
Advertisement
2.8 Sound settings (Bass/Treble)
By pressing and holding the balance button BAL (8) the right-left balance of the output signal
can be adjusted globally for all input channels by means of the volume control (9). The current
setting is shown in the display (6) on the right side while the BAL button is pressed. As soon
as you release the button, the set value is stored and the unit returns to its normal operating
state.
The integrated tone control electronics for adjusting the bass or treble components of the PA
30.3 is activated as soon as you make a setting under BASS or TREBLE. If a neutral setting
(BASS = 0, TREBLE = 0) is selected, the tone control electronics will remain deactivated until
one of these parameters is changed. The display will show TONE ON when the tone control is
activated and LINEAR when it is deactivated.
2.9 Reset (factory settings)
The RESET option offers you the possibility to reset the device to the original delivery state
and thus to all factory settings. The following settings are reset in the course of a RESET:
ü Individual input sensitivities (level settings). For details see section 2.6.
ü Cross-channel adjustments of the right-left balance (see section 2.7) and the bass/treble
sound settings (see section 2.8)
ü AV Pass Through function for high level inputs (17,19) (see section 1.11)
ü AV Pass Through Funktion für Hochpegel-Eingänge (17,19) (siehe Abschnitt 1.11)
To perform a RESET, switch off the device with the mains switch (26) on the back. Then press
and hold the TREBLE button (3) and the LEVEL button at the same time and switch the unit
on again with the power switch (26) on the back. Now press the BAL button (8) to perform the
RESET or BASS (4) to cancel the process. Wait until the unit changes to standby mode. Your
PA 30.3 integrated amplifier is now reset to its factory settings.
2.10 Automatic power-off
The PA 30.3 integrated amplifier is equipped with an energy-saving automatic power-off. If no
music is played for a period of 20 minutes or no function is activated on the unit, the PA 30.3
automatically switches to standby mode. By pressing the on/off button (2) the unit can of
course be switched on again at any time.
The automatic switch-off can be deactivated or reactivated as follows: Switch off the unit with
the rear power switch (26). Keep both keys BASS (4) and TREBLE (5) pressed and switch on
the unit with the rear power switch (26). Depending on the selected setting, the display appears:
AUTO OFF ACTIVE or AUTO OFF NOT ACTIVE. You can change the setting by repeatedly
pressing the LEVEL button (7) and then permanently store it by pressing the POWER button
(2).
15
Advertisement
Table of Contents
