Operation; First Power On / Self Test; Switching Device On / Off; Input Selection - AVM PA 30.3 Operating Instructions Manual

Table of Contents

2 Operation

When the PA 30.3 is switched on for the first time, a self-test is performed first, provided that

the unit has been completely disconnected from the power supply via the power switch (26).

The unit checks configuration and functionality of the installed components and then goes into

stand-by mode. This process may take a few seconds.

With the on/off button (2) you can switch between operation and stand-by mode. In stand-by

mode, the display is dark and the operation indicator LED (1) lights up. As soon as the machine

is in operation, the operation indicator goes out and the display (6) is activated.

ATTENTION: The device is not completely disconnected from the power supply in stand-by

mode. For complete disconnection from the power supply, press the power switch (26) at the

rear of the device or pull the power cable out of the cold appliance connection (27).

The input selection is done by turning the INPUT source selector (3). Available are one phono

input (15), two analog high-level inputs CINCH (17), one analog high-level input XLR (19), two

digital inputs OPT, COAX (20), one USB B input (18), and one channel for receiving a high-

resolution Bluetooth signal.

The currently selected program source is shown in the display (6) on the left side (e.g. IN RCA1,

IN RCA2, IN XLR, BLUTOOTH, DIG USB, DIG COAX, DIG OPTO, IN PHONO).

The integrated Bluetooth function enables the wireless transmission of a music signal from a

Bluetooth-enabled playback device such as a smartphone, tablet or computer. In order to use

the Bluetooth function, an appropriate playback device must first be connected to your PA

30.3. This process is also called Pairing and is done in no time at all.

First select the Bluetooth input with the source selector (3). The display shows ON AIR in the

lower left corner, indicating that the Bluetooth input is active and ready for operation. Then

navigate to the Bluetooth menu of your player. Make sure that the Bluetooth function is

activated and start the search process for available Bluetooth devices in your vicinity. If in

doubt, please refer to the documentation of the respective manufacturer for details on how to

operate the Bluetooth settings on your playback device.

Table of Contents