Event Notification - Grandstream Networks GSC3516 User Manual

With RTP Packets
With Secret Key Information
Enter the URL into the textbox then click "Start" to begin the ping, Results will be shown below.
Enter the URL into the textbox then click "Start" to begin the Traceroute, Results will be shown below.
When enabled, this device will allow remote access and remote collection of logs. It will automatically end when it expires.
Note: Click on "Start", then the Access Address and Expiration Time will be shown below.

Event Notification

Set the URL for events on the phone web GUI, and when the corresponding event occurs on the device, the device will send
the configured URL to the SIP server. The dynamic variables in the URL will be replaced by the actual values of the device
before sending it to the SIP server, in order to achieve the purpose of events notification. Here are the standards:
1. The IP address of the SIP server needs to be added at the beginning and separate the dynamic variables with a "/".
2. The dynamic variables need to have a "$" at the beginning. For example: local=$local
3. If users need to add multiple dynamic variables in the same event, users could use "&" to connect with different dynamic
variables. For example: 192.168.40.207/mac=$mac&local=$local
4. When the corresponding event occurs on the device, the device will send the MAC address and phone number to the
server address 192.168.40.207.
Bootup Completed Configures the event URL when phone boots up.
Registered Configures the event URL when an account in the device is registered successfully.
Unregistered Configures the event URL when an account in the device is unregistered.
Incoming Call Configures the event URL when phone has an incoming call.
Outgoing Call Configures the event URL when phone has an outgoing call.
Missed Call Configures the event URL when the device has new a missed call.
Established Call Configures the event URL when a call is established.
Terminated Call Configures the Action URL to send when phone terminates a call.
Configures whether the packet capture file contains RTP or not. Then click "Start" to start Packet
Capture or "Stop" to stop the Packet Capture.
Configures whether the packet capture file contains secret key information or not. Then click
"Start" to start Packet Capture or "Stop" to stop the Packet Capture.
Ping
Traceroute
Remote Diagnostics
System Diagnostics page
Phone Status
Call Operation