System Diagnosis - Grandstream Networks GSC3516 User Manual

3CX Auto Provision
Upgrade and Provisioning/Advanced Settings
Send HTTP Basic Authentication By Default
Enable SIP NOTIFY Authentication
Validate Hostname in Certificate
Allow AutoConfig Service Access
Factory Reset

System Diagnosis

Syslog Protocol
Syslog Server
Syslog Level
Syslog Keyword Filter
Send SIP Log
If enabled, the phone will send SUBSCRIBE requests to the multicast address in LAN during bootup for
automatic provisioning. This feature requires 3CX server support. Default setting is "Enabled".
Upgrade and Provisioning – Provision page
Determine whether to send basic HTTP authentication information to the server by
default when using wget to download firmware or config file. If set to "Yes", send
HTTP/HTTPS user name and password no matter the server needs authentication or
not. If set to "No", only send HTTP/HTTPS user name and password when the server
needs authentication. The default value is "Disabled".
Device will challenge NOTIFY with 401 when set to "Yes". The default value is
"Enabled".
Configures to validate the hostname in the SSL certificate. The default value is
"Disabled".
Set to allow access to the AutoConfig service. If not checked, access to
service.ipvideotalk.com will be disabled. The default value is "Enabled".
Resets the device to the default factory setting mode by clicking on "Start button".
Upgrade and Provisioning – Advanced Settings page
Syslog
Select the transport protocol over which log messages will be carried.
● UDP: Syslog messages will be sent over UDP.
● SSL/TLS: Syslog messages will be sent securely over TLS connection.
The URL/IP address for the syslog server.
Selects the level of logging for syslog. There are 4 levels from the dropdown list: DEBUG,
INFO, WARNING and ERROR. The following information will be included in the syslog
packet:
● DEBUG: Sent or received SIP messages.
● INFO: Product model/version on boot up, NAT related info, SIP message summary, Inbound
and outbound calls, Registration status change, negotiated codec, Ethernet link up
● WARNING: SLIC chip exception.
● ERROR: SLIC chip exception, Memory exception.
Note: Changing syslog level does not require a reboot to take effect.
The default setting is "None".
Only send the syslog with keyword, multiple keywords are separated by comma. Example: set
the filter keyword to "SIP" to filter SIP log.
Configures whether the SIP log will be included in the syslog messages. Default is "Disabled"
Packet Capture